Ammonite Led One

TECHNICAL DATA

• Material: POM head, aluminum body 
• Light source: LED, lifetime 50,000 hours 
• Light output: 1000 lumens 
• Power supply: 1 × USB-C rechargeable 18650 Li-ion battery 
• Battery capacity: 2600 mAh 
• Operating voltage: 3.7 V 
• Waterproof rating: 100 m 
• Switch type: partially rotating head 
• Modes: Steady – Strobe – SOS (available in all 4 colors) 
• Light colors: white, red, green, blue 
• Runtime: 420 min 
• Charging time: 150 min 
• Net weight: 75 g (with battery) 
• Dimensions: 107 mm × 29 mm × 27 mm 
• Operating temperature: –20 °C to +50 °C

MAINTENANCE AND STORAGE 

• Rinse the strobe thoroughly in clean, fresh water after each use. 
• All O-rings should be replaced every 12 months. 
• If O-rings are loose – replace them. 
• Lubricate O-rings lightly with silicone grease suitable for O-rings. 
• Store the strobe in a dry place at room temperature.

OPERATION / BATTERY INSTALLATION 

Charging the battery:
 Unscrew the light head counterclockwise. 
 Remove the battery and locate the USB-C charging port (near the positive terminal). 
You can use a charger, power bank, or laptop charging port. 
When connected, a red light will appear indicating charging. 
When the indicator turns green, the battery is fully charged and ready for use. 
 Insert the battery with the positive terminal facing down into the housing and the negative terminal facing the head. 
 Screw the head clockwise until fully tightened, but do not use excessive force. 

Switching On / Off:
• To turn on the strobe, gently rotate the head clockwise and release it. The strobe will turn on with steady white light. 
• Repeat the short rotation – the strobe will enter the strobe (flashing) mode. 
• Repeat again – the strobe will start flashing the SOS signal. 
• The next rotation will change the color in the following sequence: red, green, blue – each color activates first in steady, then 
strobe, and finally SOS mode. 
• The next rotation will turn the strobe off.